Powerline PLPX, Руководство пользователя

Страница: 16 / 23

16
S T E P
6
Be careful to assemble all components in the
sequence they are presented.
Inch
MM
NOTE:
Finger tighten all hardware in this step. Do NOT wrench tighten until the end of step 7.
Note:
Pulleys in this step are 4 1/4” diameter, except where noted in step 6D.
Leave all pulley bolts hand tight until step 7 is completed.
A. See diagram 1. Begin at the hanging pulley, by removing the old Short Cable that is connected to the
frame and hanging pulley. Attach either Stamped Eye End of the Leg Press Cable (19) to the hook
on the bottom of the hanging pulley. Route the Leg Press Cable (19) down toward the Lower
Main Frame.
B. See diagram 1. Route Leg Press Cable (19) around Pulley (A1) and install Pulley (A1) into the pulley
flanges in the Main Frame Connection (C) as shown in diagram 2 using:
One 23 (3/8” x 2” hex head bolt)
Two 32 (3/8” washer)
One 40 (3/8” nylon lock nut)
C. See diagram 1. Route Cable (19) along the top of the Main Frame Connection (C) and towa rd the
Main Frame (A) of the Leg P ress as shown. Route Cable (19) ar ound Pulley (A2), then see diagram 2,
and install Pulley (A2) Pulley Holder (D) as shown using:
One 23 (3/8” x 2” hex head bolt)
Two 32 (3/8” washer)
One 40 (3/8” nylon lock nut)
D. See diagram 1. Route Cable (90) along the top and thr ough the opening in Main Frame (A) as shown.
Route Cable (19) ar ound 3 1/2” Pulley (A3) and install 3 1/2” Pulley (A3) into the bottom pulley flange
in Pivot Arm (F) as shown in diagram 2 using:
One 23 (3/8” x 2” hex head bolt)
Two 32 (3/8” washer)
One 40 (3/8” nylon lock nut)
Leg Press Cable (19)
Stamped Eye End
Chain End