Powerline P1.1x, Руководство пользователя

Страница: 12 / 69

12
S T E P
3
Be careful to assemble all components in the sequence they are presented.
A. Insert Plastic Bushing (93) into the Lower Main Frame (A) as shown.
Insert Front Foot Plate (J) into the Plastic Bushing (93) in the Lower Main Frame (A) as shown and attach
using:
Two 52 (10mm x 95mm hex head bolt) - No. 6 on hardware card 1
Four 60 (10mm washer) - No. 22 on hardware card 1
Two 70 (10mm nylon lock nut) - No. 18 on hardware card 3
B. Attach End Cap (80)* to Front Foot Plate (J) as shown.
*NOTE: These parts might be pre-installed.
C. Attach Leg Extension Arm (K) to the Lower Main Frame (A) as shown using:
Two 57 (6mm x 10mm round allen head bolt) - No. 13 on hardware card 5
Two 61 (8mm x 24mm washer) - No. 24 on hardware card 3
D. Attach two End Caps (17)* to the top and bottom of Leg Extension Arm (K) as shown.
*NOTE: These parts might be pre-installed.
E. Attach End Cap (17)* to Lower Main Frame (A) as shown.
*NOTE:These parts might be pre-installed.
G. You can now wrench tighten all bolts and nuts in this step.
Leave all pulley bolts hand tight until cable installation in step 10 is completed.