Powerline P1.1x, Руководство пользователя

Страница: 10 / 69

10
S T E P
2
Be careful to assemble all components in the sequence they are presented.
NOTE:
At this point you must make sure that the gym is level, stable and in the right
location.
A. Place two Weight Stack Risers (F)* and two Rubber Donuts (29) onto Rear Leg (B) as shown.
Slide two Guide Rods (G) through the Rubber Donuts (29), through the two Weight Stack
Risers (F), and into the Rear Leg (B).
*NOTE:
Use Weight Stack Risers (F) for a 160lb. weight stack.
Do NOT use Weight Stack Risers (F) for a 210lb. weight stack.
B. Slide Weight Stack Plates (36)* onto Guide Rods (G). Make sure the opening in each Weight
Stack Plate (36), for the Weight Stack Pin (30), is facing outward.
*NOTE:
Use fifteen 10lb. plates for a 160lb. weight stack.
Use twenty 10lb. plates for a 210lb. weight stack.
C. Connect Top Plate (37) to the Selector Rod (31) using:
One 35 (10mm x 45mm flat allen head bolt) - No. 12 on hardware card 12
One 64 (10mm spring lock washer) - No. 28 on hardware card 1
D. Slide Top Plate (37) and Selector Rod (31) onto Guide Rods (G).
E. Slide two Shaft Collars (32) onto the two Guide Rods (G) as shown.
F. Insert Guide Rods (G) into Rear Upper Beam (E), and attach Rear Upper Beam (E) to the
Upper Main Frame (D) and Rear Upright (C) using:
Two 55 (10mm x 65mm hex head bolt) - No. 5 on hardware card 2
Two 70 (10mm nylon lock nut) - No. 18 on hardware card 3
G. Attach End Caps (17) to Rear Upper Beam (E) as shown.
H. Connect Rear Upright (C) to Main Frame exension. Attach Backing Plate AB to frame extension using:
Two 55 (10mm x 65mm hex head bolt) - No. 5 on hardware card 2
Two 70 (10mm nylon lock nut) - No. 18 on hardware card 3