10
Troubleshooting
This section provides a list of the more frequently encountered compressor malfunctions, their causes and
corrective actions. Some corrective actions can be performed by the operator or maintenance personnel, and
others may require assistance of a qualified electrician or Service Center.
PROBLEM
POSSIBLE CAUSE
Engine does not start.
A,B,C,D,E
Air delivery drops off.
H, I, J, L, M, N, P
Compressor does not come up to speed.
F, G, J, K
Compressor is slow to come up to speed.
F, G, J, K, L
Compressor will not unload cycle.
H, L, N, P
Compressor will not unload when stopped.
H, L, N, P
Excessive starting or stopping.
N, Q, S
Moisture in crankcase, “milky” substance in oil.
R
Oil in discharge air.
T
Safety/relief valve “pops”.
L, M, N
Low interstage pressure.
W
High interstage pressure.
V
POSSIBLE CAUSE
POSSIBLE SOLUTION
A.) Low Oil Shutdown
Fill engine with the adequate amount of oil.
B.) Cold Engine
Choke engine to start.
C.) No Fuel
Add gas to engine. Make sure fuel shutoff valve is open
D.) Engine not turned ON
Place ON/OFF switch in the ON position.
E.) Spark plug wire not attached
Attach spark plug wire to spark plug.
F.) Compressor viscosity too high for ambient temperature.
Drain existing lubricant and refill with proper lubricant.
G.) Belt tension too tight or sheaves not aligned.
Check tension/ alignment.
H.) Air leaks in discharge piping.
Check tubing connections, Tighten joints or replace as required.
I.) Compressor components leaky, broken, loose.
Inspect components. Clean or replace as required.
J.) Loose flywheel or motor pulley, excessive end play in motor shaft
or loose drive belts.
Check flywheel, motor pulley, and crankshaft drive belt tension/alignment.
Replace or repair as required.
K.) Leaking check valve or check valve seat blown out.
Replace check valve.
L.) Clogged or dirty inlet and/or discharge line.
Clean or replace.
M.) Defective safety/relief valve.
Replace.
N.) Pressure switch unloader leaks or does not work.
Realign stem or replace.
O.) Inadequate ventilation around flywheel.
Relocate compressor for better airflow.
P.) Leaking, broken or worn inlet unloader parts at check valve.
Inspect parts and replace as required.
Q.) Excessive condensation in receiver tank.
Drain receiver tank.
R.) Detergent lubricant in crankcase.
Replace with proper lubricant.
S.) Light duty cycle.
Increase duty cycle.
T.) Lubricant level too high.
Drain excess lubricant.
U.) Worn cylinder finish.
Deglaze cylinder with 180 grit flex-hone.
V.) Low pressure inlet valve leaking.
Inspect, clean or repair as required.
W.) High pressure inlet valve leaking.
Inspect, clean or repair as required.
Any Questions, Comments, Problems or Parts Orders
Call Powerhorse Product Support 1-866-443-2576
Содержание M46850E.1
Страница 11: ...11 Exploded View 789712 Engine ...
Страница 16: ...16 Parts Descriptions a a a a a a a a a a a Not Applicable Not Applicable Not Applicable Not Applicable ...
Страница 30: ...30 Manufactured by Northern Tool Equipment Co 2800 SouthCross Drive West P O Box 1499 Burnsville MN 55337 0499 ...
