Powerhorse M11966C.2, Руководство пользователя

Страница: 24 / 54

24
Troubleshooting
WARNING
Before troubleshooting or attempting to service, read the following safety instructions to avoid serious injury
to the operator or bystanders from moving parts that can crush or cut, burns, fire or explosion, or escaping
high pressure hydraulic fluid.
Important Safety Instructions:
1. Skid Steer off. Always make sure the skid steer engine is off before cleaning, repairing or adjusting the
splitter, except as recommended by the manufacturer.
2.
Hydraulic safety. High fluid pressures and temperatures are developed in hydraulic log splitters. Hydraulic fluid
escaping through a pin hole sized opening can burn or puncture skin, resulting in wounds that could cause blood
poisoning, infection, disability, gangrene, amputation, or death. Therefore, the following instructions should be
heeded at all times when inspecting or servicing the hydraulic components of the log splitter:

Turn off skid steer engine, move all split control levers back and forth to relieve pressure, and disconnect
hydraulic lines before changing or adjusting hydraulic system components such as hoses, tubing, fittings or
other components.

NEVER check for leaks with your hand. Leaks can be located by holding a piece of cardboard or wood (at least
two feet long) with your hand at one end and passing the other end over the suspected area (wear eye
protection). Look for discoloration of the cardboard or wood.

If injured by escaping fluid, no matter how small the wound is, see a doctor at once. A typical injection injury
may be a small puncture wound that does not look serious. However, severe infection or reaction can result if
proper medical treatment is not administered immediately by a doctor who is familiar with injection injuries.
Problem
Wedge will not move Solution: A,D,E,H,J
Slow wedge speed when extending or retracting Solution: A,B,C,H,I,K
Wood will not split or splits extremely slow Solution: A,B,C,F,I,K
Skid steer engine bogs down during splitting Solution: G
Skid steer engine stalls under low load condition Solution: D,E
Cause Solution
A- Insufficient oil to pump Check oil level in reservoir
B- Air in oil Check oil level in reservoir, check for leaks in the
suction line
C- Excessive pump inlet vacuum Check pump inlet hose for blockage or kinks
D- Blocked hydraulic lines Flush and clean the splitter hydraulic system
E- Blocked control valve Flush and clean the splitter hydraulic system
F- Low control valve setting Adjust control valve with a pressure gauge
G- High control valve setting Adjust control valve with a pressure gauge
H- Damaged control valve Return control valve for authorized repair
I- Internal control valve leak Return control valve for authorized repair
J- Damaged cylinder piston Return cylinder for authorized repair
K- Internally damaged cylinder Return cylinder for authorized repair
Any Questions, Comments, Problems or Parts Orders
Call Powerhorse Product Support 1-866-443-2576