Trouble Shooting
The Foot pedals appear
to be struck in place or
are difficult to move.
Pedal resistance seems
to high.
I cannot remove the red
shipping plugs from the
stabilizer tubes.
The Lateral Thigh Trainer
squeals or makes noise.
Problem
Solution
This temporary “lock up” problem is usually a result of the unit being
used continuously for an extended period of time. The stepping resist-
ance produces heat which causes the internal disc to become sluggish.
To unlock the pedals, place the resistance lever in the “FAST” position.
While holding onto a doorframe or chair to secure your balance, use one
foot to tap hard on higher pedal to unlock the internal resistance disc.
The resistance system of the Lateral Thigh Trainer can be slightly
adjusted from its original factory settings. To do this, gently turn your
unit and lay it on its back. See the resistance bolt (Part#27) found on
the bottom of the unit (refer to the parts identification drawing and
place the resistance lever in the “Fast” position and loosen this bolt one
full turn counter-clockwise. Turn your unit over and move the resistance
lever from the fast to the slow and back again to the fast position. Then
grasp the pedals and gently move them from side to side. The unit’s
resistance has now been set to a lower level.
Insert a Philip screwdriver or similar screwdriver (longer is better)
into the hole in the red plug and pry the plug out. It is okay to destroy
the plug, since it is only used to protect the stabilizer bars from
damage during shipping.
Make sure all screws and bolts are securely fastened. Also, a small
amount of lubricant such as WD-40 can be added to reduce friction
and noise. Areas to lubricate are the bushings (Part #3) as well as the
sprocket area (Part #10).
CAUTION: Always wipe off excess lubricant so as not to damage or stain
carpets and floor coverings. Never spray lubricant on your Lateral Thigh
Trainer directly after use when resistance mechanism could be hot.
19
Содержание LTT782436
Страница 1: ...Model LTT782436...