Powerfix Profi+ 296661, Инструкции по эксплуатации и безопасности

Страница: 10 / 70

10 GB/CY
Before use
Charging the product
Note: Remove all packaging materials from the product.
Note: You can recharge the product using a normal household socket
or using your car‘s 12 V connection.
Note: The fuse of the car charger adapter
11
can be exchanged.
The technical data of the fuse must comply with information given in
the section “Technical data”. The fuse may only be replaced by a
qualified electrician.
CAUTION! Do not connect the product to your car‘s 12 V connection
if the car battery is already old and worn. Doing so could mean that
the car engine will no longer start.
Note: In order to use the product without a USB cable
12
, you need
to recharge the rechargeable battery before use. The charging process
takes about 4 to 5 hours. The rechargeable battery is firmly integrated
into the base of the product.
Note: Charge the product for approx. 12 hours prior to first use.
Connect the USB cable
12
with the USB connector of the power
adapter
10
or the car charger adapter
11
.
Connect the micro-USB connector on the USB cable
12
to the
micro-USB input socket
8
on the product.
Plug the power adapter
10
into a socket, or plug the car charger
adapter
11
into the 12 V socket in your vehicle.
Note: During charging, the charging indicator
9
lights up red. When
charging is complete, the charging indicator
9
lights up green. When
the charging indicator
9
is green, pull the power adapter
10
out of
the socket or the car charger adapter
11
from the 12 V connection.
Disconnect the adapter from the product to prevent the battery from
discharging.
Use
RISK OF ACCIDENT! Preferably do not use the product whilst
driving the vehicle. When using the product in a vehicle, be sure this does
not endanger the driver or the passengers. Always store and secure the
product so that even full braking does not pose a risk of injury from the
product or product damage.
You can secure the product by using the hook
5
or the magnetic
base
3
on a flat, ferromagnetic surface. Use the joint
6
to tilt
the product up to 180 ° on the magnetic base.
CAUTION! Please note the position of your hands whilst turning
the magnetic holder to prevent pinching your fingers (see Fig. C).