28
GB
Special safety precautions
For use with SDS type drills and chisels only.
Always wear protective glasses when using
for drilling or chiselling or similar tasks
where chips, sparks and splinters can fl y up.
Never drill into a wall or other surface/item
without checking what is on the other side.
If the machine comes into contract with
electrical cables, pipes etc, it can cause
major material damage and can become
conductive if you cut an electrical cable.
Never use the chisel function with the drill
chuck, as it may damage the chuck.
Never switch between drill and chisel/
hammel drill whilst the machine is running.
Preparation
Fitting chisels
• Apply a little grease to the shaft of the
chisel to be fi tted (12).
• Pull collar (1) back and insert chisel into
bushing (2).
• Turn collar until the chisel is locked in
place. Release collar.
Fitting drills
• Screw drill chuck (10) securely onto
adapter (11). Pull collar back and insert
adapter into bushing.
• Open drill chuck using spanner (8), and
insert drill bit (13).
• Tighten chuck by hand, and then with
spanner.
Fitting support handle
• Fit support handle (3) and secure in
posiiton required by turning clockwise.
Fitting depth stop
• The depth stop (14) is used to stop the
drill at a preset depth.
• Loosen the support handle by turning
anticlockwise.
• Insert depth stop in hole on support
handle.
• Set depth stop to desired depth and
tighten handle.
Use
Selecting drill and hammer functions
The drill function selector (7) switches
between drilling and hammer drilling. The
chisel function selector (4) switches between
drilling and chiselling.
•
Fornon-hammer drilling
in soft
materials, the hammer drill function
selector must be aligned with the drill
symbol, and chisel funcion selector
aligned with the drill- and hammer
symbol.
