4
©
All rights reserved. All trademarks are property of their respective owners.
Do not connect devices that draw either massive power shortly or half-wave rectified current - such as
hairdryer, vacuum cleaner, laser printer, and plotter.
Note
: Although you may use the UPS immediately, maximum back up time will not be available yet. It is
recommended to charge the batteries for a minimum of 8 hours before use.
Connect the input cable to the UPS and the other end to the mains. The battery will automatically
charge when connecting to the main power.
Connect the loads to the UPS; Ensure receptacles are connected firmly.
(Optional) To protect your telecom/internet system, use RJ45/RJ11 cable to install the input/output
cable with matching in/out jack.
4.
Operation
Necessary information for the operation of the unit is covered in this chapter. Normally UPS runs
automatically, but on a few occasions such as just after installation, all procedures are described herein.
4.1 General Description
As Line-Interactive UPS, it is capable of providing clean and stable power to your critical system. While the
UPS regulates and filters power fluctuation, it also keeps the battery charged for any emergency.
Automatic transformer regulates over and under-voltage power.
During a power failure, the UPS immediately provides backup power from the battery to support
your essential equipment.
Power transference is typically achieved uninterrupted within 4 milliseconds.
Line-Mode/Battery-Mode
UPS will operate in Line-Mode that supports power and charge battery while connected to power.
During a power failure, the UPS will switch to Battery-Mode, in which power is maintained from the battery.
In case of failure time exceed.
Battery-Mode duration, UPS will shut down until voltage return to prevent battery discharge.
Diagnostic Test
While the advanced battery management system monitors the conditions of the batteries, it sends
early warnings if a battery replacement is needed. Diagnostic tests can be performed from the control panel.
4.2 System Configuration
The UPS device and battery make up the system. Depending on site and load requirements, certain
additional options are available as tailored solutions. Please consider the following when planning your UPS
system:
The total demand for the protected system shall dictate the output power rating (VA). When
measuring demand, please allow a margin for future expansion and calculation error.
Battery-mode duration needs dictate the battery size. If the load is less than the UPS nominal
power rating, then the actual backup time is longer.
4.3 UPS Control
Control panel functions
Display
Function Description
Display
Function Description
LED Display
Line Mode(Green)
UPS operating with Main power
Overload(Red)
Load exceed UPS capacity
Battery Mode(Yellow)
UPS operating with battery power
V
Output Voltage
Displaying UPS output voltage
Battery Fault(Red)
Battery Fault/Overload occurred
Battery Replacement: steady light
Charger Failure: steady light
Overload: Rapid flash
Battery Level
Display battery remaining During
battery or charger failure, the
indicator will flash along with the
fault indicator
Button Display
ON/OFF/TEST/Silence Button
The master button for UPS control, refer to Button Operation
Button operation
Cold Start function
When the main power is disconnected from UPS, it is capable of starting with battery power for users’
needs. Simply start the UPS as the instruction below.
“On/Off/Test/Silence” button
Turn on the UPS
Switch on the Load
Press the "ON" button until a single "beep" alarm disappeared or the LED display turns on.
Shut Down the UPS
Switch off the Load
Press the "OFF" button for 3 seconds during Line/Battery-mode.
