PowerBoss, Inc. Copyright 2010
PB# 4100033 Rev.* 06/10
Armadillo 9X Series Sweeper
Page 17
ELECTRICAL SYSTEM
Battery Cleaning
1. Combine baking soda and water in a strong
solution.
2. Brush the solution over the battery top,
including terminals and cable clamps. Make
sure the solution does not enter the battery.
3. Using a wire brush, clean the terminal posts
and cable clamps.
4. Apply a thin coating of petroleum jelly to the
terminals and cable clamps.
Battery Replacement
CAUTION
Remove the negative battery cable before you
remove the positive battery cable. This is done
to prevent accidental electrical shorting which
can result in personal injury.
1. Disconnect the negative (-) cable and then the
positive (+) cable.
2. Remove the battery.
3. Install the new battery.
4. Connect the positive (+) battery cable first,
then the negative (-) cable.
Circuit Breakers
If a circuit breaker trips, it can be reset by pressing
the reset button in the center of the breaker. (The
circuit breakers are located on the instrument
panel below the steering wheel).
Fuses
Fuses are located in the fuse panel behind the
hopper on the fire wall upper right corner when
facing the unit
CAUTION
Safety Arm Must Be Engaged When Checking
These Fuses
FUSES
CIRCUIT
BREAKER
TROUBLESHOOTING AND REPAIR
