SPEAKER CONNECTION FOR BRIDGING TWO AMPS
The mono woofer must be connected between the speaker (+) terminals of the two amplifiers and use at
least #12 gauge speaker wiring as shown above.
Install a #12 gauge wire link between the speaker (–) terminals of the two amplifiers as shown above. If this
is not done, the system will not function properly, and damage to the amplifiers may result.
Total impedance of speakers must be over 2-ohms.
If the impedance drops under 2-ohms, critical
damage to the amplifier will occur.
DUAL LINK CAUTION!
When externally bridging the speaker outputs as shown above, the amplifier
must see a 2-ohm load or higher. Below 2-ohms will cause internal damage to the amplifier and void
the warranty.
Fig.15 Dual Link Speaker connection (minimum 2 ohm load)
MASTER AMP SIDE PANEL
SLAVE AMP SIDE PANEL
19
