4. DUAL LINK AMP TO AMP BRIDGED CONNECTION
You can connect two of the same model number ASA3 Series amplifiers and double the output power into a
minimum 2-ohm load (do not mix two different model amplifiers or trouble will occur).
IMPORTANT
– Do not attempt wiring the Dual Link Power Doubling circuitry unless you are a qualified installer.
Bridging two amplifiers (of same model) can be done via the BRIDGED switch and wiring the two amplifiers
as follows:
Be sure to set the BRIDGED switch on the first amplifier to MASTER, and set the second amplifier to SLAVE.
Use the supplied RJ-45 cable to connect the two amplifiers via the BRIDGED CONNECTION ports.
When using the Dual Link Power Doubling configuration, set the GAIN control, SUBSONIC control, Bass EQ
and LPF crossover on the amplifier selected as the MASTER. These controls except for the GAIN control are
inactive on the (second) SLAVE selected amplifier.
Fig.14 Dual link Preamp connection
MASTER AMP SIDE PANEL
SLAVE AMP SIDE PANEL
