Power Apex Bike, Инструкция по эксплуатации

Страница: 9 / 20

Walls
1. Please ensure you have removed the transport blocks as per page 6.
2. Your shed will come with a number of wall sections. The quantity of these will depend which size you
ordered. Please see the components table to confirm which panels you should have for your Power Apex
Bike Shed.
3. Start with the 2ft panel that will be part of your 6ft wall – position this on top of the floor panel. Ensure the
side of the panel is flush with outer edge of floor (but not sitting on the bearer). Then position one of the
end panels (which will either be 2ft, 3ft and 4ft) at the end (and sit this on the bearer) and secure these
panels together from the inside using the 50mm screws provided. Use three screws per join.
Important
!
When securing panels together ensure they line up at the top (so the building is square) and that only the ends of
the cladding are shown, which will later be covered with corner strips).
This is only in the corner when the side meets the gable.
PAGE 8 OF 18