Assembly
• Make sure the handlebar is in its highest position.
Hint:
Please see Assembly Step 1 on page 8.
• Wrap the plastic tie around the brake cable, power wire
and the handlebar.
• Insert the flat end of the plastic tie into the opening
in the square end of the plastic tie. Pull the flat end of
the plastic tie with pliers to be sure it is tight around
the handlebar.
• Using safety scissors, cut off the excess plastic tie.
Throw the excess plastic tie away.
9
6
Handlebar
Brake
Cable
Power Wire
Cut Off
Excess
Plastic Tie
Plastic Tie
• Adjust the handlebar so that the brake handle is towards
the front of the scooter.
• Fit the front wheel onto the head tube so that the
fork
bends toward the front
of the scooter.
7
• Tighten the nut in the lower clamp with the Allen wrench.
Do not over-tighten.
5
Fork
Front of
Scooter
Head Tube
Front
Wheel
8
• Insert a bolt through one side of the fork, head tube and
out through the other side of the fork.
• Turn the front wheel so that it is sideways, as shown.
• Attach the nut to the bolt. While holding the nut with an
adjustable wrench, tighten the bolt with the Allen wrench.
Do not over-tighten.
IMPORTANT!
Assembly is now complete, but you
must
adjust the brake before first-time use
. Please proceed
to the next section
Adjusting the Brakes
, page 10.
Lower
Clamp
Allen
Wrench
Brake Handle
