Power Stroke PS80516B, Руководство оператора

Страница: 12 / 44

Page 8 — English
NOTE: This tool is heavy. To avoid back injury, lift with your
legs, not your back, and get help when needed.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.

Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.

If any parts are damaged or missing, please call
1-877-617-3501 for assistance.
PACKING LIST
Pressure Washer
25 ft. High Pressure Hose
Trigger Handle
Spray Wand
Quick-Connect Nozzles (3) with Nozzle Storage
Detergent Injection Hose
Handle
Wheel (2)
Axle (2)
Hitch Pin (2)
Bolt (2)
Lock Nut
Upper Spray Wand Holder
4-Cycle Engine Lubricant (SAE 30)
Disposable Funnel
Operator’s Manual
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
ASSEMBLy
TOOLS NEEDED
See Figure 1a.

Combination wrench
ATTACHING THE WHEEL ASSEMBLy
See Figure 2.

Locate the axles, hitch pins, and wheels. Remove the
hitch pins from the axles.

Slide the axle through the hole in the center of the wheel.

Lift the machine and slide the combination into the wheel
mounting hole in the machine base as shown.

Push the hitch pin into the hole on the end of the axle to
secure the wheel assembly.
NOTE:
The hitch pin should be pushed into the axle until
the center of the pin rests on top of the axle.

Repeat with the second wheel.
INSTALLING HANDLE AND WAND HOLDERS
See Figures 3 - 4.
Installing handle:

Align the handle with the holes in the frame.
 Push and hold the button on the handle as you slide the
handle into the holes in the frame.
Installing spray wand holders:

Align upper spray wand holder with holes in handle, as
shown.

Slide long side of upper spray wand holder through handle
and tighten securely with lock nut.

Loosen lock nut on lower wand bracket. Rotate lower
spray wand holder outward about 90 degrees and tighten
securely.

Place end of assembled wand into lower bracket. Wand
should then rest easily on upper bracket.
ATTACHING DETERGENT INJECTION HOSE
See Figure 5.
Before detergent can be used with this machine, the deter-
gent injection hose must be attached.

Push the open end of the clear detergent injection hose
securely over the fitting as shown.
NOTE:
Keep hose away from hot surfaces.

Place the filtered end of the detergent injection hose in
the bottle of detergent.
ASSEMBLING THE SPRAy WAND TO THE
TRIGGER HANDLE
See Figure 6.

Place the threaded end of the spray wand in the connec-
tor on the end of the trigger handle.

Turn the connector clockwise until it stops. This secures
the spray wand in place.