Power Solid PRO 3.3 10KVA, Руководство пользователя

Страница: 52 / 64

3.3 Audible Alarm
Description Buzzer status Muted
UPS status
Bypass mode Beeping once every 2 minutes
Yes Battery mode Beeping once every 4 seconds
Fault mode Beeping continuously
Warning
Overload Beeping twice every second
No
Others Beeping once every second
Fault
All Beeping continuously Yes
3-4. Single UPS Operation
1. Turn on the UPS with utility power supply (in AC mode)
1) After power mains is connected correctly, set the breaker of the battery pack
to “ON” position (this step only necessary for long-run model). Then set the
line input breaker to “ON” position. At the same time the fan will start running
and the UPS will start initialization. In just a few seconds, the UPS will supply
power to the loads via the Bypass mode.
NOTE: When UPS is in Bypass mode, the output voltage will be directed from
mains after you switch on the input breaker. In Bypass mode, the load is not
protected by the UPS. To protect your precious devices, you should turn on the
UPS. Refer to next step.
2) Touch “CONTROL” and select “UPS on/off” icon. It will show “Turn on UPS?”
in screen and select “Yes”. Refer to On/Off UPS screen.
3) In just a few seconds, the UPS will enter into AC mode. If the mains is
abnormal, the UPS will operate in Battery mode without interruption.
NOTE: When the UPS runs out battery, it will shut down automatically in Battery
mode. When the mains is normalized, the UPS will auto restart in AC mode.
2. Turn on the UPS without utility power supply (in Battery mode)
1) Make sure that the two strings of batteries are connected correctly in order
of ”+,GND,-” terminals and the breaker of the battery pack is at “ON” position
(only for long-run model).
2) Press the “ ” button to set up the power supply for the UPS. UPS
will enter to power on mode. After initialization, UPS will enter to “No Output
mode”.
3) In just a few seconds, the UPS will be turned on and enter to Battery mode.
44