POWER SMITH PVLR4000A, Руководство оператора

Страница: 5 / 22

FIG 2
A B
C D
BATTERY PACK
BATTERY PACK
hOLDER
LOCKING PIN
BATTERY
SYMBOL
FIG 3
FIG 4
BATTERY PACK
BATTERY POwER
INDICATOR
ChARGING
PORT
BATTERY
ChARGER
RuBBER
INSERT
5
English
ASSEMBLY INSTRUCTION
SETTING UP AND BREAKING DOWN THE LIGHT (FIG 2)
Your work light is fully assembled and ready to use out of the box.
To Set Up the Light:
From folded position A to working position D.
1. Unwrap the storage strap (18).
2. Release the leg locking clip (10). See position A.
3. Expand the tripod legs (11) and then lock the leg locking clip. See
position B.
4. Place the light head locking button (2) in unlock position, then flip
the light heads (1) up. See position C.
5. Release the tripod locking clips (7), raise the tripod (8) and lock
the tripod locking clips. See position D.
6. Adjust the light heads (1) to a desired position.
To Break Down the Light:
From postion D back to position A.
1. Release the tripod locking clips (7), lower tripod all the way down
and lock the tripod locking clips.
2. Fold the light heads (1) down in a tube shape.
3. Release the leg locking clip (10).
4. Raise the leg connector (9) until the light heads nest inside.
5. Lock the leg locking clip.
6. Wrap the legs with the storage strap.
You may also refer to the "QUICK START GUIDE" sheet which comes with the product.
INSTALLING AND REMOVING THE BATTERY PACK (FIG 3)
A 12V lithium-ion battery pack (Model# PVLAB121) is pre-installed under the tripod pole.
NOTE:
Remove the insulation tape on the battery terminals before
using.
To Remove the Battery Pack from the Light:
slide down the
battery locking pin, and then remove the battery as shown in FIG 3.
To Install the Battery Pack:
from the side with the "battery
symbol", slide the battery pack into the battery holder all the way
until it locks in place with a click, as shown in FIG 3. Lightly pull on
the battery to ensure it is locked into place and will not accidentally
fall out.
OPERATION
CHARGING THE BATTERY PACK (FIG 4)
1. Plug the battery charger into a power source.
2. Unplug the rubber insert to expose the charging port.
3. Connect the battery charger to the charging port.
4. The battery power indicator will light and show the charging status:
Red light flashing: Low power and charging.
Yellow light flashing: Over 50% power and charging.
Green light flashing: Over 80% power and charging.
Solid green light: Fully charged.
You may charge the battery pack either installed or removed from the
light. If charging while installed, the light works while the battery is
charging.