Power smart PS5040, Инструкция по эксплуатации

Страница: 10 / 28

10
Energy-saving switch
When the energy-saving switch is in “ON” position, the energy saving equipment controls the engine
rotate speed according to the connected loads. There will be good fuel consumption and low noise.
When the energy-saving switch is in
“
OFF
”
position, the engine will always run in rated rotate speed no
matter it is connected to the loads or not (See the parameter table for details).
Note: Please set the energy-saving switch to “OFF” position when connect to air compressor, sinking
pump etc. because these equipments need large starting current.
GENERATOR PREPARATION
The following section describes steps necessary to prepare the generator for use. If after reading this
section, you are unsure about how to perform any of the steps please call (800) 791-9458 Mon-Fri 9-5
EST for customer service. Failure to perform these steps properly can damage the generator or shorten its
lifespan.
Unpacking
Unpack the generator and all its parts. Do not discard the carton or any packaging until the generator is
completely assembled.
Step 1 - ADD OIL
WARNING: This engine is not filed with oil before send out to the factory. User must add
the proper amount of oil before operating the generator for the first time. Any attempt to
crank or start the engine before it has been properly filled with the recommended type and
amount of oil may result in engine damage and void your warranty.
The oil capacity of the engine crankcase is 20.3 fl. oz. For general use (above 40° F), we recommend
10W-30, 4-stroke engine oil.
ENGINE OIL RECOMMENDATIONS
Select good quality detergent oil bearing the American Petroleum Institute (API) service classifications
SJ, SL, or SM (synthetic oils may be used). Use the ASE viscosity grade of oil from the following chart
that matches the starting temperature anticipated before the next oil changes.
Engine Oil Temperature Recommendations