Power smart DB2801RB, Инструкция по эксплуатации

Страница: 10 / 68

10
ASSEMBLY
The following section describes steps necessary to prepare the snow blower for use. If after reading
this section, you are unsure about how to perform any of the steps please call (800) 791-9458 Mon-Fri
9-5 EST for customer service assistance. Failure to perform these steps properly can damage the snow
blower.
WARNING: To prevent accidental starting that could cause serious personal injury, always
remove the battery pack from the tool when assembling parts.
WARNING: If any parts are damaged or missing, do not operate this product until the parts
are replaced. Use of this product with damaged or missing parts could result in serious personal
injury.
WARNING: Do not attempt to modify this tool or create accessories not recommended for
use with this product. Any such alteration or modification is misuse and could result in a hazardous
condition leading to serious injury.
Unpacking
Grasp the rear handle and the front part of the product at the same time to carefully lift the tool up and
out of the carton. Remove any other accessories from the carton. Make sure that all items listed in the
packing list are included.
Unpack the snow blower and all its parts and compare against the list below.
 Snow Blower
 Discharge Chute Assembly
 Battery Pack
 Charger
 Owner’s Manual
 Safety Key
ASSEMBLY
Your Snow Blower will require some assembly. Please complete the following steps before using
your Snow Blower.
Step 1: Unfolding the Upper Handle
1.
Open the quick-release levers on both sides and gently pivot the upper handle upwards
until they come to a stop. Fig.1
2.
Close the quick-release levers and then tighten the knobs to secure the upper handle in
place.
Fig.1