Power smart 76604L, Инструкция по эксплуатации

Страница: 15 / 21

15
Angle Adjustment

Loosen the bevel scale bracket (10) for angle adjustment.

Adjust the base plate (3) to the desired angle between 0°to45°

Tighten the bevel scale bracket
（
10
）
.
CUTTING METHODS
Parallel Cut Adjustment

Loosen the lock knob of edge guide.

Slide the edge guide through the slots in the shoe to the desired width.

Tighten the lock bolt to secure it in the position.

Ensure that the edge guide rests against the wood along its entire length to give a consistent parallel
cuts.
Pocket Cuts
A pocket cut is a cut that must be made inside the area of the work-piece rather than starting from an
outside edge and working inward. Pocket cuts can be very dangerous for the novice to attempt because of
the need to manually retract the lower guard and perform a plunge cut which is potential hazardous.

Hold the lower blade guard by the handle.

Rest the front of the base flat against the work-piece with the rear handle related so the blade does not
touch the work-piece.

Start the saw and let the blade reach full speed.

Guide the saw down into the work-piece and make the cut.
WARNING:
Always cut in a forward direction when pocket cutting. Cutting in the reverse
direction could cause the saw to climb up on the work-piece and back toward you.
Cutting large sheets

Large sheet or boards require support to prevent bends or sags. If you attempt to cut without levelling
and properly supporting the work piece, the blade will tend to bind, causing kickback.

Support the panel or board close to the cut. Be sure to set the blade adjustment so that you can cut
through the material without cutting into the table or workbench.
Suggestion: use two by fours to support the board or panel to be cut. If the piece is too large for the
workbench, use the floor with the two-by fours supporting the wood.