Power Innovations INTegral Line 650 VA, Руководство пользователя

Страница: 14 / 22

14 Power Innovations INTegral Line-Interactive Uninterruptible Power Supply
—650 VA
4.2—Cold Start
When the system is powered up using only battery power, the LED light will be turned OFF until the button is pressed.
To cold-start the system, press the button while the system is not connected to an AC input source. The light will
illuminate, and the system will beep twice to indicate that it has been started.
After one (1) second, the system will beep a third time and the green LED light will flash. These signs indicate that no
utility source has been connected and the system has been started using battery power.
4.3—Running on Battery Power
When the UPS is ON and in Battery (Backup) mode, the UPS will beep every four (4) seconds.
Note
The UPS buzzer will be enabled automatically in severe cases such as overload, overheat, or low-
battery conditions.
4.4—No Outputs Connected
When power is not being transferred to the load, the UPS will beep and the green light will flash.
For more information, see
5
—Troubleshooting
.
4.5—System Power OFF
Press the LED light button for two (2) seconds. The system will beep twice as it turns OFF.
4.5.1
—While Connected to Input
The UPS will be disconnected from the output, with the green LED light blinking until the AC source has been
disconnected.
4.5.2
—While in Battery (Backup) Mode
If the system has been powered OFF, the light will turn OFF.
4.6—Storing the System
Disconnect input power from the unit’s rear panel if it will not be used for extended periods of time.
If the UPS is stored for longer than two months, plug it back into a power supply for at least 24 hours to fully restore the
battery charge before use.