Power-Flo Pumps & Systems • 877-24PUMPS • www.powerfl opumps.com
2
General Safety Information
Model Number
MFG Date
AMPS
VOLTAGE
PHASE
60 Hz HP
877-24 PUMPS
www.powerflopumps.com
C
US
® Power-Flo is a registered trademark of Power-Flo Technologies Inc.
Other brand and product names are trademarks or registered trademarks of their respective holders.
Alteration Rights Reserved. 6/09, 8/09, 9/09, 11/09
IMPORTANT!
Prior to installation, record Model Number, MFG Date, Amps, Voltage,
Phase and HP, from pump name plate for future reference. Also record the
Voltage and Current Readings at Startup:
Before installation, read the following
instructions carefully. Failure to follow
instruction and Safety information
could cause serious bodily injury,
death and/or property damage. Each
Power-Flo pump is individually factory
tested to insure proper performance.
Closely following these instructions will
eliminate potential operating problems,
assuring years of trouble-free service.
ALL RETURNED
PRODUCTS MUST BE
CLEANED,
SANITIZED, OR
RECONTAMINATED
PRIOR TO SHIPMENT,
TO INSURE EMPLOYEES WILL NOT
BE EXPOSED TO HEALTH HAZARDS
IN HANDLING SAID MATERIAL.
ALL APPLICABLE LAWS AND
REGULATIONS SHALL APPLY
.
DO
NOT
introduced into any sewer,
either directly, or through a kitchen
waste disposal unit or toilet:
Seafood
Shells, Aquarium Gravel, Cat Litter,
Plastic Objects (toys, utensils, etc.),
Sanitary Napkins or Tampons, Diapers,
Rags, Disposable Wipes or Cloth,
Medications, Flammable Material, Oil or
Grease, Strong Chemicals, Gasoline
.
• Risk of electric shock. To reduce risk of
electric shock, always disconnect pump
from power source before handling.
Lock out power & tag.
• Installation must be in accordance
with the National Electric Code and all
applicable state and local codes.
• Installation and servicing is to be
conducted by qualifi ed personnel.
• These pumps are NOT to be installed
in locations classifi ed as hazardous in
accordance with the National Electric
Code, ANSI/NFPA 70.
• Keep clear of suction and discharge
openings. Do not insert fi ngers in
pump with power connected.
• Always wear eye protection when
working on pumps.
•
DO NOT
use power cord to lift pump.
Protect cable from cuts and punctures.
Do not handle power cable with wet
hands.
• Do not us these pumps in water over
145˚F. Consult Power-Flo for high
temperature pump models.
• Pumps build up heat and pressure
during operation-allow time for pumps
to cool before handling or servicing.
This pump is
NOT
intended for
use in swimming pools or any
body of water with human
contact. Pumps when used as a
decorative water fountain
pump
MUST
be used in circuit
protected by a Ground Fault
Interrupter.
• Bronze/brass fi tted pumps may contain
levels higher than considered safe for
potable water systems. Government
agencies have determined that leaded
copper alloys should not be used in
potable water applications.
PFGPC- 2HP
Submersible Grinder Pumps
BACK TO INDEX
