Rotary Tool
9
Visit www.princessauto.com for more information
8352965
V 3.02
INSTALLING ACCESSORIES
WARNING! Use only accessories that are recommended
for this rotary tool. Follow the instructions that
accompany the accessories. The use of improper
accessories may result in injury to the operator, damage
to the tool or property damage.
1. Turn the switch OFF and disconnect the tool from
the power source.
2. Depress the spindle lock button (1) and slowly
turn the collet nut (2) until the spindle lock
button locks the spindle (see figure 4).
3. While holding the spindle lock button down, turn
the collet nut counterclockwise until the collet is loose inside the collet nut.
4. Insert the accessory (3) into the collet.
NOTE:
a. Make sure the correct collet is used for the accessory. If the collet is too large, replace the
collet with the next smaller size.
b. Insert the accessory at least 3/4 in. into the collet.
5. Press the spindle lock button and engage it in the spindle. While holding the spindle lock button
down, hand-tighten the collet by turning it clockwise.
NOTE:
Do not use pliers to tighten the collet nut. Use a small wrench. Over tightening will cause
damage to the tool.
6. Pull on the accessory to endure it is securely in place.
CAUTION! Before using any accessory, carefully read the instruction or the owner’s manual for
Fig.4
