Rotary Tool
8
For technical questions call: 1-800-665-8685
8352965
V 3.02
ASSEMBLY AND OPERATION
SPEED SELECTION
Set the rotary tool speed by rotating the variable speed
control dial (1) to the appropriate speed (see figure 1).
Position the speed control dial at “1” for the slowest speed,
“3” for medium speed and “MAX” for the highest speed.
ON / OFF SWITCH
To turn the switch ON, push on the lower part of the ON /
OFF switch (1) (see figure 2). To turn the switch OFF, push
on the upper part of the ON / OFF switch (2).
CHANGING THE COLLET
Some accessories require the use of different sized
collets. Collet sizes can be 1/16 in., 3/32 in. and 1/8 in.
It is important to ensure that the collet size matches the
accessory.
NOTE: This tool includes the most commonly used collet:
1/8 in.
WARNING! Using a collet that is too large for the
accessory will result in the accessory possibly being
thrown from the tool causing serious injury.
1. Turn the tool switch OFF and remove the plug
from the power source.
2. Depress the spindle lock button (1) and slowly
turn the collet nut (2) until the spindle lock
button locks the spindle (3) (see figure 3).
3. While holding the spindle lock button down, turn
the collet nut counter clockwise until it
is removed.
4. Remove the collet (4) by pulling it out of
the spindle.
5. Insert the replacement collet into the spindle
and replace the collet nut by turning it clockwise
while holding the spindle lock button down.
NOTE: Do not tighten the collet nut without an accessory
installed in the collet. You will damage
the collet.
Fig.3
Fig.1
Fig.2
