8976052
MINIMIG 100E Flux-Cored Welder
V4.0
24
For technical questions call 1-800-665-8685
2. Open the welding unit's side panel.
3.
Loosen the drive tension adjustment knob and lift the Drive tension arm
up off the drive roller.
4.
Turn the wire spool
counterclockwise. Hold onto the
wire itself while turning the spool or
the wire will unspool when it
becomes free of the torch liner. Push
wire end through the spools hole
and bend to secure. Remove wire
from the welding unit.
5.
Lay torch cable and torch handle
straight out in front of welding unit.
6. Remove the torch Strain Relief
Clamp by removing the four screws.
7.
Take the torch handle halves apart by
removing four Phillips head screws.
8. Remove the hanging hook from the
two case halves by carefully pulling
it apart until it is free from
the torch.
9. Remove liner from outer torch
sleeve by pulling from torch end.
10. Install new liner, starting from torch end and feeding towards unit.
11. Push the new liner back into the neck of the torch until it is fully seated.
12. Return all components to the handle casing and realign them as they were
originally. Be sure all o-rings are returned to their original positions.
13. Fit liner for length at feeder end by cutting liner with wire cutters.
14. Reinstall liner holding clamp at feeder.
15. With both halves of the handle case in place, tighten the four Phillips head
screws.
16. Replace hanging hook.
17. Reinstall the welding wire (see Install the Welding Wire).
18. Close the side panel.
19. The torch liner replacement is complete
Fig. 7
