Power Fist 8911323, Руководство пользователя

Страница: 6 / 28

8911323 20 Ton Hydraulic Shop Press V1.0
6 For technical questions call 1-800-665-8685
10. Do not expose the fluid to an ignition source. Hydraulic fluid has a
combustible flash point of approximately 200°F (93°C). Consult the
material Safety Datasheet (MSDS) for your hydraulic oil to determine the
actual flashpoint.
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the missing
part before operating. Failure to do so could result in a malfunction and
personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
Make sure that all items in the parts list are included.
ASSEMBLY & INSTALLATION
When this manual refers to a part number, it refers to the included Parts List.
Use the exploded drawing in the Parts Breakdown as your guide to assemble
the shop press. Lay all parts and assemblies out in front of you before
beginning. A second person will make several steps easier to carry out.
1.
Attach one base section (#11) to the left post of the press frame (#15) using
bolts (#9), washers (#12), lock washers (#13) and nuts (#14).
2. Attach a support bar (#10) to each end of the base section (#11) with bolts
(#9), washers (#12), lock washers (#13) and nuts (#14).
3. Attach the other end of each support bar to the post with bolts (#9),
washers (#12), lock washers (#13) and nuts (#14).
4. Check that the press is level and tighten the bolts.
5. Repeat step 1 through 4 to attach the other base section to the right post.
6. Insert the frame pins (#8) into the holes in the posts, then insert the joined
press bed frame (#6) into press frame and onto bed frame pin.
7. Position the nut (#40) over the hole in the upper press frame.
8. Attach the pump (#39) to the right post using bolts (#16) and washers
(#12).
9. Connect the oil hose (#30) to the pump (#39). Assemble the pressure
gauge (#38).
10. Tighten all bolts and nuts.