V 4.1
20 Ton Hydraulic Shop Press
8604597
Visit www.princessauto.com for more information
9
OPERATING THE SHOP PRESS
WARNING! Ensure that you read, understand and apply the safety
instructions and warnings before use.
1. Lift or lower the bed frame until it is in position. Insert a bed frame pin (#19)
into the left and right posts beneath the bed frame. Lower the bed frame so it
rests on the bed frame pins.
2. Place the heel blocks (#17) on the bed frame (#18), then insert a workpiece on
the heel blocks
3. Close the release valve (#40) on the pump by turning it clockwise.
4. Pump the handle or pedal until the ram nears the workpiece.
5. Align the workpiece and ram to ensure center-loading.
6. Pump the handle or pedal to apply load onto the workpiece.
7. When the work is done, stop pumping the handle or pedal. Slowly and
carefully remove load from workpiece by turning the release valve
counterclockwise in small increments.
8. Once the ram has fully retracted, remove the workpiece from the bed frame.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or worn
components. Only use identical replacement parts when servicing.
3. Follow instructions for lubricating and changing accessories.
4. Only use accessories intended for use with this tool.
5. Keep the tool handles clean, dry and free from oil/grease at all times.
6. Maintain the tool’s labels and name plates. These carry important information.
If unreadable or missing, contact Princess Auto Ltd. for replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
