Assembly
WARNING: ALWAYS BE SURE THE TOOL IS IN THE “Off” POSITION BEFORE
CHANGING ACCESSORIES, CHANGING COLLETS OR SERVICING YOUR
CORDLESS ROTARY TOOL.
Collet
To loosen, first press shaft lock button and rotate the
shaft by hand until the lock engages the shaft
preventing further rotation.
CAUTION
Do not engage lock while the Rotary Tool is running.
With the shaft lock engaged use the collet wrench to
loosen the collet nut if necessary. Change accessories by inserting the new one into the
collet as far as possible to minimize runout and unbalance. With the shaft lock engaged,
finger tighten the collet nut until the accessory shank is gripped by the collet. Avoid
excessive tightening of the collet nut.
Operation Instructions
The cordless rotary tool provides high-speed power. It serves as a carver, grinder,
polisher, sander, cutter, power brush, and drill. Accessories come in a variety of shapes
for a number of different jobs.
Charging the Tool
The Cordless Rotary Tool does not come fully charged. The tool is equipped with a
removable battery pack. Be sure to charge pack prior to initial use. For best results on
first charge, charge pack overnight.
1. To charge the battery pack put the switch in the “OFF” position.
2. Squeeze release tabs on both sides of battery pack, and remove pack from back of
tool.
3. Align marks on battery pack with marks on charger, insert battery pack into charger.
4. Plug charger into the power source. The green L.E.D. light indicates connection has
been made and the battery pack is charging. Under normal usage the battery pack
requires 3 hours charging time to reach full capacity.
5. When charging is completed, remove pack from charger.
6. Align marks on battery pack with marks on the housing of tool as shown. Squeeze
release tabs, insert battery pack into back of tool, and release pressure on tabs so it
locks in place.
