8723728
12V Red/Amber Magnetic Tow Light Kit
V4.0
6
For technical questions call 1-800-665-8685
Parts Required
•
4-way flat connector (vehicle end) with 4 ft wire harness.
•
Tap-In Wire Splice x 4
WIRING COLOUR CODE
This is the wiring configuration of the 4-way Flat Connector (#23). Consult your
owner’s manual if vehicle has a different wiring colour code.
White: Ground
Brown: Running lights
Yellow: Left stop and tum lights
Green: Right stop and tum lights
INSTRUCTIONS
IMPORTANT! If your vehicle has turn signals separate from the brake lights,
install an electronic turn signal converter above the splice.
1. Disconnect the vehicle battery to avoid a short circuit or an electrical
shock. See the vehicle owner’s manual for instructions.
2. Connect the yellow, green and brown wires of the wire harness connector
to the vehicle wiring using the wire splices.
a. Insert a wire (#22) fully into the wire splice’s
enclosed channel.
b. Place the splice around matching vehicle wire.
c. Close the splice cover and press firmly. This will
cut through the wire insulation of each, creating
an electrical connection.
d. Verify that all wires are held securely.
3. Attach the white wire of the 4-way flat connector to a grounded location on
the vehicle.
4. Connect the male and female 4-way connectors.
5. Reconnect the vehicle battery.
6. Test the brakes and turn signals to confirm the wiring is correct.
Fig. 1
Fig. 2
