Power Electronics SD750K, Руководство по аппаратному обеспечению и установке

Страница: 55 / 100

POWER ELECTRONICS SD750K
POWER CONNECTION
53
The two environments are divided in four categories C1 to C4 that are summarized in the following
table.
FIRST ENVIRONMENT SECOND ENVIRONMENT
C1 C2 C3 C4
Restricted Installation [1] NO YES YES YES [2]
Notes
[1] “Restricted Installation” means that the installation and commissioning must be carried out by specialist
personnel.
[2] C4 Category applies only for complex systems or when ratings are equal or above to 1000 V or 400 A which
are unable to comply with the limits of C3 Category. In these cases, C4 Category can be achieved by adjusting
the equipment in situ and applying the EMC recommendations.
SD750 Kompakt compliance
SD750 Kompakt variable speed drives have been designed for the industrial use (Second
Environment). The implementation of radio frequency interference filters (RFI filters) and dV/dt filters
as standard, and the correct installation following the recommendations within this manual, permit to
achieve compliance with C3 category defined in IEC/EN 61800-3.
Optionally, the SD750 Kompakt drive with non-floating earth can be installed in residential areas (First
Environment) by employing optional RFI filters that permit to achieve the C2 category.
The SD750 Kompakt is not a retail unit. It is neither a plug in device nor a movable device and it is
intended to be installed and commissioned by qualified personnel. Therefore, C1 category will not be
required.
The SD750 Kompakt with floating earth configuration can be installed in industrial (Second
Environment) IT grids. Although it does not integrate RFI filters, following the installation
recommendations within this manual and with its integrated dV/dt filter, it achieves the C3 category
defined in IEC/EN61800-3.
Connection
The SD750 Kompakt do not require the use of shielded motor cable to achieve compliance with C3
category when a correct installation is made. Wiring and Installation recommendations are included in
sections “Power connection and wiring” and “Ground connection”.
In shielded cables it is recommended to connect the shield by making 360° contact in both the drive
cabinet and the motor terminal box. As an example, EMC cable glands can be installed as shown in
the next figure.