Powercraft
07
Features
Fig. 1
1. Collet chuck
2. Ring
3. Spindle lock
4. Speed adjusting wheel
5. Clip
6. On/Off switch
The following pictograms are used in these instructions for use:
In accordance with essential applicable safety standards of European directives
Class II machine - Double insulation - You don't need any earthed plug.
Denotes risk of personal injury, loss of life or damage to the tool in case of non-
observance of the instructions in this manual.
Denotes risk of electric shock.
Immediately unplug the plug from the mains electricity in the case that the cord
gets damaged and during maintenance
The number of revolution of the machine can be electronically set
Wear ear protection
Wear eye protection
Read the users manual.
Faulty and/or discarded electrical or electronic apparatus have to be collected at
the appropriate recycling locations.
2. SAFETY INSTRUCTIONS
UK
10
Powercraft
• Compare the maximum number of revolutions allowed of the accessories with the number
of revolutions of the machine.
• When you put the machine away the engine must be switched off and moving parts must
have reached a standstill.
• Never attach an assembly spanner to your machine with a piece of string or anything
similar.
• Never use the axle locking button if the machine is operating.
• Make sure that the collet diameter is the same as the axle diameter of the accessory.
• Use a clamping device for securing the work piece.
• Keep your hands away from the work piece.
Before assembly always remove the plug from the mains.
Operation
Fig. 2
Press down the spindle lock button (2) and hold it down. Using the collet spanner you can
undo the collet (1). Put the accessory in its place. Hold down the spindle lock button
when you fasten the collet with the collet spanner.
Never operate the spindle lock button if the engine is still rotating.
Operation
Fig.2
•
Switch on the machine by engaging the on/out switch (A). By adjusting the adjusting
wheel (B) you can regulate the speed of the Combitool.
Too high a load at a low speed of the Combitool can burn out the engine.
Holding and guiding the tool
Fig. 3
•
For precision work (engraving): pencil grip (A)
•
For rough work (grinding): paring knife hand grip (B)
•
When you need to keep the tool parallel to the work surface (e.g. using a cut-off wheel):
2 hand golf grip (C)
Mounting the flexible shaft
Fig. 4a
•
Screw the black ring off the chuck and remove it.
•
Mount the flexible shaft on the Combitool, placing the inner shaft (1) in the chuck. The
black ring of the flexible shaft (2) can then be fastened onto the Combitool.
3. ASSEMBLY AND OPERATION
UK