Power Craft PC2800LR, Руководство пользователя и гарантия

Страница: 7 / 14

22 07
Operation
Engine Switch
To start and stop the engine.
Switch position:
OFF: To Stop the engine.
ON: To run the engine after starting.
Recoil Starter
To start the engine. Pull the starter grip lightly until resistance is felt, then pull briskly.
NOTE: Do not allow the starter to snap back against the engine. Return it gently to prevent
damage to the starter.
Fuel Valve
The fuel valve is located between the fuel tank and carburetor. When the valve lever is in the
ON position, fuel is allowed to flow from the fuel tank to the carburetor. Be sure to return
the lever to OFF after stopping the engine.
Maintenance
Spark Plug Service
Recommended spark plugs:
MP160; BPR6ES (NGK)
MP240, MP340, MP390; BPR5ES (NGK)
MP270; BP6ES (NGK)
To ensure proper engine operation, the spark
plug must be properly gapped and free of deposits.
If the engine has been running, the exhaust will
be very hot.
Be careful
Do not to touch the silencer.
1. Remove the spark plug cap.
2. Clean any dirt from around the spark plug base.
3. Use the wrench supplied in the tool kit to remove the spark plug.
4. Visually inspect the spark plug. Discard it if the insulator is cracked or chipped. Clean the
spark plug with a wire brush if it is to be reused.
5. Measure the plug gap with a feeler gauge.
Correct as necessary by carefully bending the side electrode.
The gap should be: 0.70-0.80 mm (0.028-0.031 in)
6. Check that the spark plug washer is in good condition, and thread the spark plug in by
hand to prevent cross-threading.
8. After the spark plug is seated, tighten with a spark plug wrench to compress the washer.
- If installing a new spark plug, tighten 1/2 turn after the spark plug seats to compress the
washer. If reinstalling a used spark plug, tighten 1/8-1/4 turn after the spark plug seats to
compress the washer.
NOTICE
The spark plug must be securely tightened. An improperly tightened spark plug can
become very hot and could damage the engine. Never use spark plugs that have an
improper heat range. Use only the recommended-spark plugs or equivalent.
Helpline No. UK / Northern Ireland 08707 323023 Rep. Ireland 1800 481 005
Web Support : www.omegawolf.com/powercraft
Model Number: PC2800LR
Helpline No. UK / Northern Ireland 08707 323023 Rep. Ireland 1800 481 005
Web Support : www.omegawolf.com/powercraft
Model Number: PC2800LR