Power Climber Wind BAP 360, Инструкция по эксплуатации и монтажу

Страница: 30 / 37

Reference: 38741 Issue date: 2018-JUL-24 Revision: L Page 30 of 37
C. Reeve the safety rope in the TITAN hoist
At roof level, uncoil the safety ropes and lay them on
the roof surface. Attach the safety ropes to the
suspension system with the safety hooks fitted to the
ropes and lower the ropes to the ground. Verify that
the rope is long enough.
Push back the slack rope lever (or tension the
suspension rope) to open the jaws of the slack rope
safety device and push the safety rope through the
slack rope compartment. Take out all slack by putting a
weight on the tail end of the safety rope.
Tip: Separately reeving the safety rope and the
suspension rope, will avoid getting them twisted
together.
D. Carry out Daily Checklist
Carry out the Daily Checklist Prior to your first ascent to install the Top limit switch
striker plates. Always check the suspension system for stability and safety before
launching the platform.
E. Install Top Limit Switch Striker Plates
The striker plate activates the top limit switch and must be clamped on the safety wire at
a distance of min 20cm from the talurit clamp.
IMPORTANT
Clamp the striker plate to the safety rope ONLY so that the
suspension rope passes freely through the slot in the plate.
REMOVING
the steel wire rope from the TITAN hoist
Tip: Remove the safety rope first and keep the suspension rope taut, so that the slack
rope safety device stays open and allows easy passage of the safety rope.
Safety rope
Manually pull the safety rope out of the slack rope safety device by hand.
Suspension
rope
Push the ‘down’ button on the CCB until the suspension rope no longer
comes out of the top of the hoist and pull out the remainder of the rope by
hand.
Tip: push up on the slack rope lever for easy removal of the suspension
rope.
After work is over check that:

The platform is cleared of tools and equipment.

All power has been switched off.

Equipment has been secured where it will not be accessible to be tampered with.