15-
1/2”
9”
1-
3/4”
WIDE EDGE OF MOTOR MOUNT PLATE
FLUSH TO BOTTOM OF JAMB
(PUSH SIDE OF DOOR)
EDGE OF DOOR
HINGE SIDE
(NOT SEEN)
3. MOUNTING THE MOTOR UNIT AND LEVER ARM SHOE
CENTER LINE
CENTER LINE
REMOVE SHOE FROM LOWER
LEVER ARM THEN USE TWO
SUPPLIED WOOD SCREWS
TO MOUNT SHOE
USE AT LEAST THE FOUR
SUPPLIED WOOD SCREWS
3.1 MOUNTING THE MOTOR UNIT:
WARNING: WEAR SAFETY GOOGLES PRIOR TO DRILLING.
ALIGN THE
WIDE
EDGE OF THE MOTOR MOUNT PLATE FLUSH TO THE BOTTOM OF THE
DOOR JAMB AND 9 INCHES FROM THE EDGE OF THE DOOR, SECURE THE MOUNT PLATE
WITH AT LEAST THE 4 SUPPLIED WOOD SCREWS. ANY HOLES IN THE MOUNT PLATE MAY
BE USED BUT IT IS ADVISED TO USE THE HOLES IN THE OUTERMOST ROWS TO FOLLOW
BEST PRACTICE TECHNIQUE. SCREW INTO SURFACES THAT ARE FLUSH TO THE BACK
SIDE OF THE MOTOR MOUNT PLATE. IT IS IMPORTANT THE SCREWS ACHIEVE A SOLID
MOUNT.
3.2 MOUNTING THE SHOE:
FIRST, REMOVE THE SHOE FROM THE LOWER LEVER ARM. WITH THE CENTER LINE OF
THE SHOE 1-3/4 INCHES BELOW THE BOTTOM OF THE NARROW EDGE OF THE MOTOR
MOUNT PLATE AND 15-1/2 INCHES FROM THE HINGE SIDE EDGE OF THE DOOR, SECURE
THE SHOE TO THE DOOR WITH 2 SUPPLIED WOOD SCREWS.
U.S. Patent 7,418,800 B1 Power Access 2300JL REV 08-05-17 ©
6