1. PRECAUTIONS AND REQUIREMENTS
6” MINIMUM
CLEARANCE FROM
TOP EDGE OF DOOR
TO CEILING
1.1 PRECAUTIONS
:
1.1.1
THE MODEL 2300JL IS NOT SUITABLE FOR DOORS THAT OPEN TO THE EXTERIOR SUBJECT TO WINDY CONDITIONS. WIND
WILL CAUSE THE MODEL 2300JL TO OPERATE IMPROPERLY.
1.1.2
VERIFY THAT YOU HAVE THE CORRECT MODEL NUMBER FOR YOUR APPLICATION. REFERENCE
MODEL CONFIGURATIONS
(PAGE 20) TO VERIFY YOU HAVE THE CORRECT UNIT. IF NOT, SEE
CHANGING HAND DIRECTION
(PAGE 15, 9.1).
1.1.3
THE DOOR THAT THE MODEL 2300JL IS TO BE MOUNTED ABOVE SHOULD BE PLUMB, SQUARE, AND NOT WARPED. THE DOOR
SHOULD NOT STICK TO THE JAMB.
1.1.4
THE DOOR THAT THE MODEL 2300JL UNIT IS TO BE MOUNTED ABOVE SHOULD HAVE STANDARD BUTT HINGES, VOID OF ANY
SPRINGS. NO OTHER DOOR OPEN OR CLOSE ASSIST FEATURES SHOULD BE ATTACHED TO THE DOOR. 20 LBS. OF INITIAL
FORCE IS APPLIED AT THE LEADING EDGE OF THE DOOR TO BEGIN THE OPENING AND CLOSING ACTIONS. FLIMSY OR
IMPROPERLY INSTALLED HINGES MAY PREVENT THE DOOR OPENER FROM OPERATING PROPERLY.
1.2 POWER REQUIREMENTS
:
THIS MODEL IS SUPPLIED WITH A 9 FOOT POWER CORD THAT PLUGS INTO A 115V AC OUTLET. WHEN THE OPTIONAL ELECTRIC
STRIKE IS PROVIDED, IT IS SUPPLIED WITH 12 FEET OF LOW VOLTAGE WIRE TO CONNECT THE ELECTRIC STRIKE PLATE TO THE
STRIKE TERMINALS ON THE MAIN CIRCUIT BOARD (SEE PAGES 10 AND 16). THE TERMINALS ARE UNIVERSAL.
WARNING: USE CAUTION AND DISCONNECT POWER WHEN WIRING ELECTRIC STRIKE.
1.3 CLEARANCE REQUIREMENTS:
AT LEAST 6” OF CLEARANCE ABOVE THE TOP OF THE DOOR IS NEEDED.
HINGE SIDE OF DOOR
U.S. Patent 7,418,800 B1 Power Access 2300JL REV 08-05-17 ©
4