Power Access 2300JL, Руководство по установке, Страница: 15 / 20

9. CHANGING HAND (ROTATION OF THE MOTOR)
M1 M2
MAIN CIRCUIT BOARD
U.S. Patent 7,418,800 B1 Power Access 2300JL REV 08-05-17 ©
9.1 CHANGING HAND IN THE FIELD :
REROUTE THE POWER CORD (AND STRIKE WIRE
IF APPLICABLE) SO IT EXITS THE UNIT ON THE
HINGE SIDE OF DOOR.
REVERSE THE TWO MOTOR LEADS ON M1 AND
M2 SO THE MOTOR WILL RUN IN THE OPPOSITE
DIRECTION. TO ENSURE CORRECT POSITIONING
OF THE MOTOR LEADS, PERFORM THE
FOLLOWING STEPS:
1. HOLD UNIT TO NEW DOOR OR JAMB POSITION
AND NOTE WHICH MOTOR LEAD (M1 OR M2) IS
CLOSEST TO THE HINGE SIDE OF DOOR.
2. PLACE UNIT ON TABLE AND, IF NECESSARY,
CAREFULLY REMOVE THE LEAD WIRES AND
REROUTE THE BLUE WIRE TO THE MOTOR
LEAD POSITION CLOSEST THE HINGE SIDE OF
DOOR. THIS ALSO POSITIONS THE BLUE WIRE
IN THE MOTOR LEAD POSITION CLOSEST TO
THE MOTOR. THE BLACK WIRE THEN
POSITIONS TO THE OTHER LEAD.
WHEN CONVERTING FROM JAMB MOUNT TO
DOOR MOUNT, REFER TO PAGE 7 AND PERFORM
THE FOLLOWING STEP:
1. REPLACE JAMB MOUNT ADJUSTMENT
FOREARM EXTENSION WITH MODEL 2413
DOOR MOUNT FOREARM - CALL 800-344-0088
TO ORDER.
ONCE THE LEAD WIRES ARE CONFIRMED IN THE
CORRECT POSITION, FOLLOW THE PROPER
INSTALLATION GUIDE TO MOUNT THE OPENER.
15