Poulan Pro PR174Y22RHPE, Руководство оператора

Страница: 13 / 16

• Always make sure that the blade is correctly
ground and balanced. To examine the blade
balance, use a 5/8 in (16 mm) diameter steel
bolt, pin or a cone balancer. Obey the
instructions included with the balancer.
• Do not use a nail to balance the blade. The lobes
of the center hole are not centered.
• Move the blade onto an unthreaded part of the
steel bolt or pin, and hold the bolt or pin parallel
to the ground. If the blade is balanced, it stays in
the horizontal position. If one of the two ends of
the blade moves down, sharpen the heavy end
until the blade is correctly balanced.
Note: The blades must be balanced after
sharpening. Do not sharpen or balance the blade on
your own. Speak to an approved service workshop.
To remove and replace the blade
1. Lock the blade with a block of wood.
2. Remove the blade bolt.
3. Remove the blade.
4. Examine the blade support and blade bolt to see
if there is damage.
5. Examine the motor shaft to make sure that it is
not bent.
6. When you attach the new blade, point the angled
ends of the blade in the direction of the engine.
7. Make sure that the blade is aligned with the
center of the motor shaft.
8. Lock the blade with a block of wood. Attach the
spring washer and tighten the bolt and washer.
See TECHNICAL DATA on page 14 for the
correct blade bolt torque.
9. Pull the blade around by hand and make sure
that it turns freely.
WARNING: Use heavy duty gloves.
The blade is very sharp and cuts can
easily occur.
10. Start the product to do a test of the blade. If the
blade is not correctly attached, there is vibration
in the product or the cutting result is
unsatisfactory.
TRANSPORTATION AND STORAGE
• Keep all equipment safe during transportation to
prevent damage and accidents.
• For storage, keep equipment in a lockable area
away from children and persons that are not
approved.
• For storage, keep the product and equipment in
a dry and frost-proof area.
• When loading or moving the product, do not go
more than the maximum recommended
operation angle of 15 degrees.
• Empty the fuel tank by operating the product until
the tank is empty
• Drain the engine oil.
• Clean the product. For more information, see
To
clean the product on page 12
.
• Tighten bolts and nuts.
• Replace or repair damaged components.
• Touch up all rusted or damaged paint surfaces.
Sand lightly before painting.
• Use the correct protective cover on the product
that keeps it dry. Do not use plastic because it
lets condensation collect and causes corrosion
on the product.
438 - 001 - 29.11.2017 13