Pottinger NOVADISC 400, Руководство оператора, Страница: 21 / 51

- 19 -
1601-GB MAINTENANCE_385
MAINTENANCE AND REPAIRS
GB
Cutter bar oil level check
• Under normal operating conditions, oil is to be
replenished annually.
Caution
Cleaning and maintenance works shall be
performed only with the machine turned
off and the mowing units lowered.
1. Lift one side of the mower bar X3 and support
it.
X3 = X2 + X1
X1 = Distance from ground to vats upper edge.
X2 = Distance from vats upper edge left to vats upper
edge right.
X3
X2 X1
NOVADISC 225: X2 = 180 mm
NOVADISC 265: X2 = set vertically
NOVADISC 305: X2 = 600 mm
NOVADISC 350: X2 = 240 mm
• The side where the oil refill screw is located remains
on the ground.
• Lift the mower bar on the other side (X1) and support
it with suitable means.
2. Leave mower bar in this position for about 15
minutes.
• This time is necessary to allow the oil to collect in
the lower area of the mower bar.
3. Remove oil fill screw (63).
The oil level is measured at the oil refill screw hole.
3. Remove oil fill screw (63).
Measure oil level through the opening (63).
4. Oil level check
Important information when measuring
the oil level:
You jack up the cutter bar depending on
the length.
The cutter bar width must be adjusted in
precise horizontal position. (see image).
4.1 Oil level for NOVADISC 305 and NOVADISC 350:
The oil level is correct if the gear oil reaches the lower edge
of the level opening (63) (OIL LEVEL).
TD17/99/10
OIL LEVEL
4.2 Oil level for NOVADISC 265:
The oil level is correct when the oil level reaches 5 mm
below the screw level.
OIL LEVEL
169-16-007
x