Page 8 of 11
7.
Place the base near
desired location. Use a dry cloth to wipe off any dirt or dust from the top edge of console,
apply high quality silicone or acrylic based bath sealant to top edge of console.
DO NOT USE PLUMBERS
PUTTY OR ANY OIL BASED SEALANT AS THIS WILL STAIN THE MARBLE
.
Carefully lift up the marble countertop (I) with basin attached to place it onto the console base.
8. Mount APOTHECARY SINK to the wall:
1)
NOTE: Adjust the
APOTHECARY SINK position to make sure drain holes are right on top of the cutout
for drainpipe on the shelf.
Place a level on the APOTHECARY SINK and with the help of another person, position the
APOTHECARY SINK against the wall at a desired location. Adjust the APOTHECARY SINK so that it is
level and then use a pencil to mark the wall through hole located in the bracket (P). These marks are the
insertion marks for the provided hardware.
Set the APOTHECARY SINK aside so you have access to its rear surface.
2) The provided toggles (N) are needed for drywall applications, but cannot penetrate into wall studs (wood).
Therefore, we recommend that you use a stud finder to determine if any of the insertion marks align with a
wall stud. If so, only a screw will be used at that mark. If not, then both a toggle and a screw will be used.
3) For marks that do not align with a wall-stud, use a screwdriver to engage a toggle (N) and position the
toggle tip against the wall at one of the insertion marks. Gently push the toggle into the wall as you rotate
the toggle clockwise. Continue rotating until the large flange of the toggle is flush with the wall. Repeat this
step with the other anchors and non-stud marks.
I
Caution: For safe handling, 2-3 people are
recommended.
Note: Always carry any natural stone vertically.
Carrying stone products flat may cause cracking
or breakage.
Caution: For safe handling, always handle the
metal tube when removing the apothecary sink!
N
N
Wall
