Potterton iHE 100, Инструкция по установке и обслуживанию

Страница: 44 / 48

iHE 42 GB/IE
Table 3.0
Code Fault Description Notes
10 Outside sensor, error Check connections and / or replace faulty sensor (B9)
20 Boiler temperature 1, sensor error Check connections and / or replace faulty sensor (B2)
26 Common fl ow temperature, sensor error Check connections and / or replace faulty sensor (B10)
28 Flue gas temperature, sensor error Check connections and / or replace faulty sensor (B8)
30 Flow temperature 1, sensor error Check connections and / or replace faulty sensor (B1)
32 Flow temperature 2, sensor error Check connections and / or replace faulty sensor (B12)
40 Return temperature 1, sensor error Check connections and / or replace faulty sensor (B7)
50 DHW temperature 1, sensor error Check connections and / or replace faulty sensor (B3)
60 Room temperature 1, sensor error Check connections and / or replace faulty sensor (R1)
65 Room temperature 2, sensor error Check connections and / or replace faulty sensor (R2)
68 Room temperature 3, sensor error Check connections and / or replace faulty sensor (R3)
70 Storage tank temperature 1, sensor error Check connections and / or replace faulty sensor (R4)
81 LPB Short circuit Check ribbon cable of OCI345 is not shorting on casing
83 LPB collision Duplicate LPB address - Check all PCBs function 6600
84 BSB address collision Room unit incorrectly con fi gured - see function 40
98 Extension module 1, error Module 1 con fi guration error - Check parameters
99 Extension module 2, error Module 2 con fi guration error - Check parameters
100 2 Clock time masters Only PCB no 1 is set as time master - see Function 6640
110 STB lockout Check connector X18a and all fl ow & return sensors
111 Shutdown limit thermostat Heat exchanger temperatures have been exceeded
119 Shutd water pressure switch Check for condensate or fl ue blockage
121 Flow temperature heating circuit 1 not reached Htg Circuit 1, time temp parameter not reached
122 Flow temperature heating circuit 2 not rached Htg Circuit 2, time temp parameter not reached
126 DHW charging temperature not reached Check operation and heat up times for DHW
127 DHW legionella temperature not reached Check operation of appliance
128 Loss of fl ame during operation Ionisation current lost after successful ignition
130 Flue gas temp too high Heat Engine is overheating. Check causes of high temperatures
133 Safety time exceeded Ignition unsuccessful after 5 attempts
151 BMU Internal error Check polarity is not reversed to the appliance
152 Parameterization error Incorrect / Con fl icting parameters input.
153 Unit manually locked Reset button stuck in
160 Fan speed threshold not reached Required fan speed not reached
171 Alarm contact 1 active Condensate or fl ue system blockage
217 Sensor error Ionisation current fault.
218 Pressure supervision Check water pressure in heating circuit
317 Mains frequency outside permissable range Check electrical installaiton
320 DHW Charging temperature, sensor error Check connections and / or replace faulty sensor (B36)
323 Water Pressure 3 too low Check water pressure in heating circuit
324 Input BX, same sensors BX sensor duplicated - check parameters
325 Input BX/extension module, same sensors BX extension module sensor duplicated - check parameters
326 Input BX/mixing group, same sensors BX Mixing Circuit sensor duplicated - check parameters
327 Extension module, same function Extension Modules duplicated - check parameters
4.5 FAULT CODES LIST