Potensic Dreamer 4K, Руководство пользователя

Страница: 15 / 28

13
Setting interface
1
2
3
4
5
Flight precautions
1. Connect drone with remote control
Connection and calibration
Calibration settings 2
Remote control settings
3
Main controller settings
1
About smart batteries 4
More 5
1. Check if the remote control, smart flight battery and mobile equipment are fully charged.
2. Check if the device body is complete and the propeller is installed correctly.
3. Check if the camera works normally after power on.
4. Check if App works normally.
5. Check if Micro SD card card is inserted and make sure the camera is clean.
6. Low power protection: the low power alarm is triggered when power is less than 20%. The drone
will intelligently trigger low power return according to the distance between the current position
and home point.
7. Loss of connection protection: after losing connection for 3 seconds, one-click return will be
triggered; during return, the drone will hover if reconnect successfully.
8. Out of control protection: if the horizontal inclination angle is over 80 degrees for 0.5 seconds,
the drone will be locked automatically to protect the motor.
The remote control and the drone are frequency-connected at the factory and can be used after
power on. But if you are replacing the remote control, it is necessary to re-connect the new remote
control and the drone. The connection steps are as follows:
A. Insert the battery to the drone, short press the power switch, and then long press for 7 seconds.
At this time, the battery indicator light is solid on, and the drone is ready for connection.
B. Press and hold the middle button of the right stick on the remote control, long press power
button at the same time, the remote control is ready for connection. (Picture 1). At this time, the
four footlights of the drone flash left and right alternatively, and the power light of the remote
control flashes slowly.