Frequent Question
Q: Why scanner block the keyboard operation?
A: Check the cable connection with your equipment, then turn
power on again.
Q: If scanner has a good read beep but nothing transferring
after read a label.
A: Using the
SETTING LIST
at
10 to show what current setting of
scanner is, or reset to Default, (or select right Interface default if
scanner to be change another interface used), then re-program
scanner again.
Q: If scanner dosen't need an Enter character addition after
each barcode label transmission.
A: Refer to postamble transmission at
60, then set
Disable
.
Q: If scanner needs to read single digit code.
A: Refer to Min. code length of code option use "01" in Chapter 4
for single code readable.
Q: If scanner isn't able to discriminate an unknown label, but
read manual very well.
A: Refer to code name at
64 to set
Enable
, read a barcode label,
then you will know what symbology is read. Beside, it maybe
need to verify checksum. Refer to verify checksum of code
option in Chapter 4, and set
Enable
.
Q: If scanner transfers character very slow or loses some
characters on screen in keyboard interface after reading a
label.
A: You may set caps lock to be
Alt+Keypad
at
11. Otherwise, it
maybe mis-match of transmission rate, therefore, you can adjust
an appropriate
Inter-char. Delay
to match your equipment. See
11.
Q: If scanner want to read a label as function key for your
apprication.
A: Refer to function key simulation at
11 and set
Enable
, then
scanner can transmit a code as function key. It is used for
keyboard interface only. Beside, you must make sure that a label
is encoded as function key, and its ASCII code is from 00
16
to
1F
16
You can refer to ASCII code table at
71.
Operation Manual
8
