5.
Pass the cable of the power adapter
through the cable exit and then connect
it to the port on the I/O plate of your
POS system. (Please refer to
Routing
and Arranging Cables
section to thread
the cable, according to the model of
your base stand.)
6.
Neatly thread the cord along the bottom
edge of the middle compartment (1), and
then use the cable tie to hold the extra
cable (2) as shown in the figure.
7.
Place back the middle compartment
bracket into place, and then secure it
using two fixing screws.
8.
Lay the POS terminal on a flat surface
with its rear facing towards you. Then,
connect the female end of power cord to
the power adapter and the other end to
the electrical outlet.
10.
To hold the power cord into place, attach the screw hole of power
adapter holder to the hole at the bottom of Gen 8E base stand,
and then use a fixing screw to secure the bracket.
Cable tie
(1)
(2)
Power Adapter
Holder
Cable Exit
17
