Part 9
Now please check the back of PD-260X display head as in the left picture in
Pix. 14
. There is a small piece of plastic cover for the “DIP switch window”.
Slide the cover downward but don’t pull it off otherwise you may have to
practice for inserting it back. You can find 6 positions of DIP switches in this
window. Adjust for the appropriate command mode used by the application
program according to below table. Switch position counts from left to right and
“ON” means pushed up as indicated in the right part in
Pix. 14
.
Switch Position
1
2
3
4
5
6
Command Mode
ON
OFF OFF
ON
OFF OFF
ADM
ON
OFF
ON
ON
OFF OFF
Aedex
ON
OFF
ON
OFF OFF OFF
Epson
ON
OFF OFF
ON
ON
OFF
Futaba
ON
OFF
ON
OFF
ON
OFF
Noritake
ON
OFF
ON
ON
ON
OFF
UTC
The factory default command mode is set to Noritake mode for normal
delivery. Please change it to Epson mode if OPOS or UPOS driver is used for
the application program.
POWER ON SIGN
With interface cable connection well installed (and with COM port power set
for serial models), turn on the HT or KS or TP Posiflex POS system, a
firmware identifier as power on sign will appear on the pole display screen for
a while to indicate that pole display is self-tested O.K. and ready to work.
USING THE CUSTOMER DISPLAY
INTERRFACE SELECTION
This series of customer display is designed to serve in HT / KS / TP / FT series
Posiflex POS systems with RS232 interface models and with USB interface
models. It is
advisable to well study the I/O port availability of the host system
before determining which interface model to be used.
When a RS232 (serial) interface model of PD-2601 / 2602 / 2603 is used, the
jumper on main board of HT / KS / TP / FT system must be modified to supply
power to the COM port designated for PD-2601 / 2602 / 2603. Whenever the
RS232 interface PD-2601 / 2602 / 2603 is to be removed from the HT / KS /
TP / FT system, consequently the jumper has to be changed back to neutralize
the COM port,
otherwise damage could occur
!