Part 4
3 pin power connector from either 12 V AC or +24 V DC power adaptor to
the“12 V DC In” or “+24 V DC In” jack in the connector area. Insert either
end of the power cable to “+24 V DC Out” jack in the connector area and
insert the other end to the power connector of Posiflex POS printer if needed.
Be sure to hear a click at each connection to obtain a firm contact. You may
now place the base on a horizontal surface and prepare to power on and adjust
the direction of the display head for best viewing effect in application.
INSTALLING PD-2600
Stand Alone Model:
This instruction is for stand alone model only. Please
unpack the inner box of pole display and it easy to find
the base, display unit with tube and adaptor separately.
Please remove the PE foam and bring out the
components carefully.
Firstly, place the display head and tube on a flat surface
and find the cable which in the end of tube. Let this
cable pass through the short tube which on the base
stand and it shows in the picture at right.
Next, please assemble the display head with tube to the
base stand which shows in the right picture. Please pay
more attention during the process since there is a hole
and a compression lock which are in the two side of tube
and marked arrow signs. Aim these two arrow signs
nearby compression lock to the holes and push the tube
to the end. After hear the “click” sound, the assembly is
complete.
Once combine the display head with tube and base stand,
please place the pole display as a horizontal position
which can easily to check the bottom plate.
Please plug the cable to the connector which showing
“To Display” and route the cable as arrowed in the right
picture.