Part 4
side cable cover of HT series as in the upper right picture and gently press it
down and slide aside to open it and connect the USB cable of KP-200U/ KP-
210U to the extended USB port as shown in the lower right picture in last page.
EXTENDED PS/2 KEYBOARD CONNECTION
Refer to the right picture on back
of KP-200 / KP-210 with a partially
enlarged picture at inclined angle. In the
cavity found at lower rear side of KP-200 /
KP-210, there is a PS/2 KB jack. Connect
a standard PS/2 keyboard device to this
jack and insert the cable from the PS/2
keyboard device into the cable pass for
strain relief and fixation when an extended
PS/2 KB is required.
KEYTOP LAYOUT
Keytop Replacement
The keypad in KP-200/ KP-200U/ KP-210/ KP-210U is organized
into 2 parts: a 4 by 4 numerical keypad area and a 4 by 6 matrix minus a 2 by 2
square recess programmable keypad area. However, this keypad allows some
layout alterations by the system integrator. Besides the standard single key
installed, there are double keys and blank keys for purchase to provide more
convenient interface with the user.
When replacement of keytop is required, it is advisable to use a
flattop (minus sign) screw driver (Do not use the attached key clip for this
operation.) to help getting the key top off gently. Please always first orientate
the key tops as below before inserting any keytop into the case of the keypad.
Failure to do so could result in permanent damage not covered in product
warranty.
Please always match the latching tab on bottom stem of keytop with
the tab in guiding hole and gently press the key top down till a click sound is
heard as indicated in the pictures below.
Single key top
Latching tab
Double key top
Tab in the
guide hole
KP-200 / KP-210
Rear View
Cable Pass
KB Jack
