JETSTREAM
USER MANUAL
14
MOUNTING THE REGULATOR
ON A TANK
The procedure below only describes the way you mount the regulator and it
does not replace all the steps you’ve learnt during your dive training.
• Carefully open the tank valve and clear any dirt/debris/water in the valve
connection. Then close the valve.
• Remove the protective cap from the first stage DIN connection.
• Make sure the o-ring on the first stage DIN connection is mounted and
without any damage. Then mount the first stage on the valve. Turn the
connection wheel until you can feel that the first stage is firmly attached to
the valve.
• Carefully open the tank valve completely and then turn the valve knob half a
turn in reverse.
• Purge the second stage a couple of times, to clear the second stage of any
debris left from the previous dive.
• Check the pressure gauge to make sure the tank is full.
• Breath on the primary second stage and the octopus to make sure they work
(provide air). If the inhalation air smell or taste bad, the air in the tank should
be replaced.
• The regulator is now ready to dive with.
IMPORTANT!
Inspect the o-ring, and make sure it is absolutely free from
particles and/or grease. Do not touch the o-ring.
Grease and particles can cause a fire.