Auto-RTS Transceiver Control
In Windows applications the driver must be enabled and disabled as needed, allowing all cards to share a
two wire cable. This card controls the driver automatically. With automatic control, the driver is enabled
when data are ready to be transmitted. The driver remains enabled for one additional character's
transmission time after data transfer is complete and then is disabled. The receiver is usually enabled, but
is disabled during transmissions, and then re-enabled after transmission is completed (plus one character
transmission time). The card automatically adjusts it's timing to the baud rate of the data. (Note: Thanks
to the automatic control feature, the card is ideal for use in Windows applications)
Specification
Communications Interface
•
I/O Connection:
9 Pin DBM Connector.
•
Character length:
5, 6, 7, or 8 bits.
•
Parity:
Even, odd or none.
•
Stop Interval:
1, 1.5, or 2 bits.
•
Serial Data Rates:
Up to 115,200 baud, asynchronous. A faster range of
rates, up to 460,800, is achieved by jumper selection on
the card. Type 16550 buffered UART.
•
Address:
Continuously mappable within 0000 to FFFF (hex) range
of PCI-bus addresses.
•
Receiver Input Sensitivity:
+200 mV, differential input.
•
Common Mode Rejection:
+12V to -7V.
•
Transmitter Output Drive Capability:
60 mA, with thermal shutdown.
Environmental
•
Operating Temperature Range: 0 °C. to +60 °C.
•
Storage temperature Range:
-50 °C. to +120 °C.
•
Humidity:
5% to 95%, non-condensing.
•
Power Required:
+5VDC at 50 mA typical, +12VDC at 5 mA (Quiescent),
15 mA (Maximum).
•
Size:
4.80 inches long (122 mm).
Manual PCI-ICM-1S
6