System Installation
FUDA2-S1x11 Series Panel PC User’s Manual
2-1
Chapter 2
System Installation
This chapter provides you with instructions to set up your FUDA2-S1x11 Series Panel
PC. Definitions and locations of all the interfaces are described so that you can easily
configure your system.
2.1 Embedded Board H/W Jumper Setting Introduction
FUDA2-S1x11 Series Panel PC adopts PEB-99A4 mother board. You may configure
the Panel PC by setting jumpers of the mother board to match the needs of your
applications. To select any option, cover the jumper cap (SHORT) or remove (NC) it
from the jumper pins according to the following instructions.
*Note: NC stands for “Not Connect”.
Component side:
