EUDA2 Series 12”/15”/18.5” Panel PC User’s Manual (ver2.1) 28
6.1.3 Insert Memory module
The EUDA2 Panel PC Series system, EUDA2-S1220/EUDA2-S1520/EUDA2-S1821, is fully integrated at the
system assembly line before shipment. It’s not necessary for end users to do any assembly unless installing the
optional HDD, RAM, CF and/or Power Input. Installation of these optional components is described below.
1. Unscrew the IPC back cover to detach it
2. Remove the IPC back cover
Screw (M2.5x6L)
3. Insert Memory module to the slot.
4. Press down the Memory module and finish.
Figure 6-7: Installation of Memory
6.1.4 Hard Disk Installation Method
Unlike IDE bus, each Serial Advanced Technology Attachment (SATA) channel can only connect to one SATA hard
disk at a time; the installation of SATA is simpler and easier than IDE, because the SATA hard disk doesn’t
require setting up Master and Slave, which can reduce mistake of hardware installation. The step 1-4 is HDD
installation, and step 4-1 is HDD un-installation. (
※
The HDD height must be less than 10mm).
1. Remove the screw of HDD tray upper
cover on PPC
2. Push the rod to release HDD tray from PPC
3. Install the HDD into tray with screws
(
※
Must use M3X4L Screw 4pcs in Package)
4. Push HDD tray back into PPC system
2
2
